Applications
Shot blasting, chosen by what you make
No one buys a shot blasting machine because they want a shot blasting machine. They buy it because castings are leaving the foundry with sand baked into the surface, or because plate is going to the paint shop with mill scale still on it. The machine is the last decision, not the first.
So the range is organised the way the problem arrives: by industry, then by workpiece, then by the standard that has to be met. Fourteen machine types are built in Botou, but most buyers end up in one of four families — tumble belt, hook type, mesh belt, roller conveyor — and the rest exist because a particular production line asked for something those four cannot do.
Three questions that decide the machine
Can the part be tumbled? If it is a small-to-medium casting or forging that survives falling over itself, a tumble belt gives the lowest cost per tonne. If it is thin-walled, machined, or has features that would chip, it cannot go in a barrel.
Can it hang? Frames, weldments and large castings hang from a hook and rotate through the blast stream; the hook arrangement — single station, Y-track, or a closed loop — sets the throughput far more than the wheel power does.
Does it have to travel? Flat plate, profiles and parts that must not touch each other run through on a mesh belt or a roller conveyor, in line with cutting and painting.
Published industry guides
What a quotation needs from you
Four numbers decide the price and the cycle time, and none of them is "a shot blasting machine": the heaviest workpiece and its largest dimension, how many of them per shift, the surface standard written as SA 2.5 or SSPC-SP10 rather than "clean", and what happens to the part next — paint, galvanising, welding, machining or dispatch. Send those four and the reply is a configuration with a cycle time, not a brochure.
Send the four numbers and we will price the machine around them — or tell you that the machine you asked about is the wrong one.
